OBAPROOF GROUT 2215 PUMPABLE SHRINKAGE COMPENSATED CEMENTITIOUS GROUT
Specifications
Details
OBA GROUT 2215 PUMPABLE SHRINKAGE COMPENSATED CEMENTITIOUS GROUT / GROUT SIMEN YANG BOLEH DIPAM / CEMENT KUAT KERAS
Obaproof Oba Grout 2215 is a pumpable dual shrinkage compensated, self- levelling, pre-bagged cementitious grout with extended working time to suit local ambient temperatures.
OBA GROUT 2215 adalah grout simen prabungkusan yang boleh dipam, mempunyai kompensasi penguncupan dua kali ganda, dan tahap sendiri merata dengan masa kerja yang diperluas untuk sesuai dengan suhu persekitaran tempatan.
Uses:
Obaproof Oba Grout 2215 is suitable for repairs to the following concrete structures: Machine foundations
• Columns in precast construction
• Concrete anchors
• Bridge bearings
• Honeycombs (pre-packed grouting)
• Cavities
• Gaps
• Recesses
• Rail beds
Obaproof Oba Grout 2215 is suitable for grouting works with clearances as low as 5mm.
Characteristics / Advantages:
• Easy to mix and apply
• Good flow characteristics
• Rapid strength development
• High ultimate strengths
• Extended working time
• Impact resistant
• Non-corrosive
• Non-toxic
• Chloride free
• Dense and non-shrink (2 step expansion- Gaseous expansion in plastic stage & crystalline expansion in hardened stage)
• Good pumping properties Tested for compatibility with drinking water, PSB report 57S030976-SLE-2
Substrate Quality/Pre-Treatment:
The substrate should be prepared by suitable mechanical preparation techniques such as high pressure water, breakers, grit blasting, scabblers, etc. All absorbent surfaces must be well saturated with clean water, but free of any surface water or puddles prior to the application of Obaproof Oba Grout 2215.
Concrete, mortar and stone
surface must be sound, clean, free from frost, oils, grease, standing water and all loosely adhering particles and other surface contaminants.
Metal surfaces ( iron and steel)
Surfaces should be clean, free from scale, rust, oil and grease.
Mixing:
Place about 70-80% of the pre-measured clean water (depending on consistency required- refer to "Mix Ratio") into a clean container and gradually add the whole bag of Obaproof Oba Grout 2215 into it while continuously mixing. Add the remaining water and continue mixing until the desired consistency is obtained. Mix for 2-3 minutes with a slow speed drill and paddle (~500rpm). For large quantities mixing, the use of a forced-action mixer of rotating pan, paddle or trough type is preferred. Free fall mixers should not be used.
View more about OBAPROOF GROUT 2215 PUMPABLE SHRINKAGE COMPENSATED CEMENTITIOUS GROUT on main site






